Logo

P2130 Engine Trouble Code

Meaning of P2130 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P2130 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for P2130 code is occuring now you should check P2130 repair processes.
Now don't ask yourself; What should you do with P2130 code ?
The solution is here :

P2130 Possible Solution:

P2130 Engine

Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all.

P2130 Code Meaning :

P 2 1 3 0
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) Fuel Rail/System Pressure - Too High Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector) Shift Solenoid E Performance or Stuck Off

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P2130 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P2130 engine trouble code is about Shift Solenoid E Performance or Stuck Off.

Main reason For P2130 Code

The reason of P2130 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

P2130 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.